Table of ContentsUSA SIPS USA SIPS panels being placed in the press. Precision glue application machine uses calibrated weight. USA SIPS panels being machined for true square and prepared for spline interface to other panels. USA SIPS panels stacked for shipment Panels being loaded on the trailer for shipment. USA SIPS panels arrive at your job site. The start is at the bottom. A good level, square slab is a must. Installing foam seal and wood sill plate around the slab. Plate should be installed using a laser level for accuracy. Preparation and gluing of corner panel to begin panel erection. First panel starting at a corner after completing installation of plates. First corner goes together First corner up. Another corner with larger panel. Another corner up. Stabilizing walls with bracers prior to installing roof panels or trusses. Putting up header panel for larger/taller openings. Finished header for garage door opening. Gable and wall assembled on the ground for large cathedral ceiling. This structure shows combination of trusses with a conventional roof together with SIPS cathedral roof/ceiling. Advanced preparation of roof panels. Roof panel being installed with skid loader and teleboom attachment. Close-up of panel being installed with teleboom attachment. Finished gable and wall panel assembly Building with USA SIPs is easy. Is it really this much fun? |
Author: Keith
Email: sales@usa-sips.com Home Page: http://www.usa-sips.com Best experienced with |
